3D Printer Profiles

WAIT! Please read before moving on:

The profiles below are outdated and considered historical. I have them listed & up for download here for those who wish to try them regardless of this.

If you're looking for the Siepie Profile (or any of my older profiles) - it's important to know they are ONLY compatible with much older versions of Cura, and will not work with more recent versions of Cura. They still work with older versions if you are still interested in using them.


What am I using now? Cura has improved significantly since I published these profiles, and I use the starting "Fine" profiles as a starting point currently.

My resin profiles are available to my patrons over at Patreon.


(Cura) Siepie CR10/Ender 3 - Small Minis PLA Base 1.0

Author: /u/ Siepie (Modified by 3D Printed Tabletop)
Printers: CR10 & Ender 3
Slicer: Cura
Purpose: Small Miniatures (<30mm)
Version: 1.0

3DPT CR10 & Ender 3 - DragonsLarge Minis PLA Base 1.2

Author: 3D Printed Tabletop
Printers: CR10 & Ender 3
Slicer: Cura
Purpose: Dragons/Large Minis above 0.30mm layer height (0.12mm layer height default, 60mm speed, 10% infill, supports auto enabled)
Version: 1.2


3DPrintingPro Mini & Terrain Profile (Cura - 4.1 and earlier)

Author: Greg Kourakos (3D Printing Pro on YouTube)
Printers: Ender 3, Ender 5, Ender 2, CR-10
Slicer: Cura
Purpose: For Minis: Leave as is; For Terrain: Adjust the Layer Height to 0.12-0.2mm (or leave at 0.08mm for additional detail).
Version: 1.0

Notes: This profile was derived from the Fat Dragon Games Profile made by Tom Tullis. Adjust temperature and retraction settings to your machine. Disable support if the print does not need it.

3DPrintingPro Mini & Terrain Profile (Cura - 4.2 + 4.3)

Author: Greg Kourakos (3D Printing Pro on YouTube)
Printers: Ender 3, Ender 5, Ender 2, CR-10
Slicer: Cura
Purpose: For Minis: Leave as is; For Terrain: Adjust the Layer Height to 0.12-0.2mm (or leave at 0.08mm for additional detail).
Version: 1.0

Notes: This profile was derived from the Fat Dragon Games Profile made by Tom Tullis. Adjust temperature and retraction settings to your machine. Disable support if the print does not need it.